The first step is to cut the multiplex board to the size of 70 x 25 cm. If it has not already been cut to the appropriate dimensions in the DIY store, this should not be a major problem with a jigsaw. The stoppers, which are the same width as the board and around 3-5 cm long, must then be attached to the end of the board with wood glue. Then simply fix in place with the screw clamps and leave to harden for several hours. Depending on your taste, you can then round off the corners of the balance board or leave it as it is. The use of a template is recommended for rounding off. An old paint can, for example, guarantees a consistent rounding at all corners. Simply place it on the board and trace the rounding with a pencil. Use a jigsaw to cut along the markings and then sand down with sandpaper. Optionally, the surface can be roughened similar to a skateboard. The best way to do this is to use grip tape from the skate store.

Shopping list for the do-it-yourself balance board

• 50cm PVC pipe / plastic waste water pipe 110 / 500 mm

• 40cm x 60cm board leftover box

• Roof batten